tcsjc Comments - Answer Overflow

Follow up replaced the tool board and even though I’m using a pt1000 thermistor on uhf plus 2 it shows add out of range if I have sensor type pt1000 and 110 degrees over actual temps if I dont use it was fine before a ratos update though

11 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 2/21/2024 in #ratos-support

custom bed mesh

where do i put it in ratos printer.cfg?

7 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 2/5/2024 in #fix-my-printer

VC3 500 with EBB42 ttc errors

Anyone?

3 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 2/5/2024 in #fix-my-printer

VC3 500 with EBB42 ttc errors

Its now either ttc or lost communicattion with toolboard

3 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 1/24/2024 in #fix-my-printer

Inability to maintain Hotend and bed temps VC3.1 500

how do i mark as solved when the time comes?

13 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 1/24/2024 in #fix-my-printer

Inability to maintain Hotend and bed temps VC3.1 500

Im pretty sure its the dupont connector was shaking loose so switched it for a jst. Im just trying to solve another issue which will allow me to run it long enough to be happy its resolved

13 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 1/24/2024 in #fix-my-printer

Inability to maintain Hotend and bed temps VC3.1 500

thanks all

13 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 1/24/2024 in #fix-my-printer

Inability to maintain Hotend and bed temps VC3.1 500

yeah i think i fixed this issue now on to the next one!

13 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 1/24/2024 in #fix-my-printer

Inability to maintain Hotend and bed temps VC3.1 500

Correction this on closer inspection is hjust the heated bed. It will randomly see the temp as a negative value (varies) and stop the print but is fine for hours before failure the logs that just show declining temps are post shutdown messages it seems ( at least my untrained eyes read the klippy log that way

13 replies

RRCRat Rig Community [Unofficial]

•Created by tcsjc on 1/24/2024 in #fix-my-mesh

V3.1 500 Mesh causing inconsistent print