lary9920
RRCRat Rig Community [Unofficial]
•Created by lary9920 on 12/19/2024 in #ratos-support
Latest update rendered Vcore 4 nonfunctional
62 replies
RRCRat Rig Community [Unofficial]
•Created by lary9920 on 11/17/2024 in #fix-my-printer
Layer Shift Problem
I have a weird layer shift problem affecting multiple models out of multiple slicers.
As shown in the picture, at a height of about 6mm off the build plate (for this model), the layers start progressively shifting approximately equally in both x and y, from x min and y min toward x max and y max.
This has also happened on Benchy models (about 3 mm off the bed) and a different model of functional parts (large flat model just a few layers off the bed.) Its the same shift in the same direction.
There is no movement of the build surface. I don't hear any change in the movements when listening.
I recently installed the IDEX upgrade kit. This is currently happening only with T0. I included a pic of my first 2 color benchy only to show that it did not shift after installation of the kit.
0.6 mm nozzles in both toolheads. Otherwise stock. I checked the grub screws in the pulleys and they're tight. I don't understand on the IDEX motion system how I'm getting a shift in both x and y.
Any troubleshooting ideas would be greatly appreciated 🤔 .
Any troubleshooting ideas would be greatly appreciated 🤔 .
7 replies
RRCRat Rig Community [Unofficial]
•Created by lary9920 on 11/17/2024 in #ratos-support
Temperature List for T1
Quick question. In Temperatures on the Mainsail Dashboard, when I look to set the temp of T0 I can select from a list of preset temps. When I look at T1 it only gives me 0. Is there a place that I can modify these lists?
6 replies
RRCRat Rig Community [Unofficial]
•Created by lary9920 on 10/4/2024 in #fix-my-print
Elephant Foot on Vcore 4
Hi all,
I was hoping for a little advice on how to address elephant footing on my prints on my new Vcore 4. I'm not sure its new, I just think it hasn't matter much until my current model, which won't function with the fat lower layers.
I'm pretty much running with defaults. I've messed with cooling a bit on the PLA profile. I've been waiting for my IDEX kit, so I haven't really gone crazy with "making it my own."
But I've never dealt with Beacon before. I can't tell if this might be a z-offset issue causing an oversquished first layer?
I'm also new to OrcaSlicer. I tried doubling the default compensation, but it hasn't helped much. So now I'm leaning toward re-running my beacon calibrations. - Is there anything you'd do first before re-calibrating to eliminate other variables? (Again - new to Beacon) - Is there anything you would due prior or during beacon calibration to ensure optimal results that may correct this? - Am I missing something in OrcaSlicer that may be causing this? Thanks to the braintrust.
I'm also new to OrcaSlicer. I tried doubling the default compensation, but it hasn't helped much. So now I'm leaning toward re-running my beacon calibrations. - Is there anything you'd do first before re-calibrating to eliminate other variables? (Again - new to Beacon) - Is there anything you would due prior or during beacon calibration to ensure optimal results that may correct this? - Am I missing something in OrcaSlicer that may be causing this? Thanks to the braintrust.
4 replies
RRCRat Rig Community [Unofficial]
•Created by lary9920 on 8/7/2024 in #fix-my-resonance
Vcore 4 400
3 replies