Mietzekatzi Comments - Answer Overflow

Mietzekatzi

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by JayBo on 3/11/2024 in #fix-my-printer

Octo board not behaving correctly

20 replies

RRCRat Rig Community [Unofficial]

•Created by JayBo on 3/11/2024 in #fix-my-printer

Octo board not behaving correctly

Again, please make a simple drawing of what you have connected. Because now it looks like you connected both ends of the bed heater to the SSR... Although I’m afraid that judging from what I saw, you should consult an electrician for setup. Please be careful! To test if the board works, I’d start by removing all cables, except the thermistors. In this configuration, the board can start up Klipper without warnings (once configured via RatOS).

20 replies

RRCRat Rig Community [Unofficial]

•Created by JayBo on 3/11/2024 in #fix-my-printer

Octo board not behaving correctly

Please explain what you have connected to the heater and bed-out ports. From the image, it looks suspicious…

20 replies

RRCRat Rig Community [Unofficial]

•Created by Kälte Kiste on 2/3/2024 in #german-support

Bed Mesh Fehler mit Beacon

Mich wundert allerdings auch, dass das so schräg ist. Nach dem Z-Tilt sollte dein Mesh flach sein, außer die Punkte wo Z-Tilt gemessen wird, haben auch irgendwelche Probleme. Du kannst die Punkte auch mal näher Richtung Mitte bewegen, der Algorithmus kommt trotzdem klar damit

15 replies

RRCRat Rig Community [Unofficial]

•Created by Kälte Kiste on 2/3/2024 in #german-support

Bed Mesh Fehler mit Beacon

Kann das Beacon mit Faulty Regions umgehen? Dann könnte man die Stelle einfach überspringen ohne das Mesh kleiner zu machen? https://www.klipper3d.org/Bed_Mesh.html#faulty-regions

15 replies

RRCRat Rig Community [Unofficial]

•Created by DanielDC88 on 1/30/2024 in #fix-my-print

[Klipper] Enabling Bed Mesh Levelling Squishes Dense Parts

I don’t own an Ender, but it looks like A) Did you check if the coupler for the Z axis is loose?

5 replies

RRCRat Rig Community [Unofficial]

•Created by DOAmatrix on 1/11/2024 in #ratos-support

4 pin Fan cant be controlled

Maybe Microfit Jr might be an option

43 replies

RRCRat Rig Community [Unofficial]

•Created by DOAmatrix on 1/11/2024 in #ratos-support

4 pin Fan cant be controlled

Ah interesting. I’m also using one for the wire-to-wire connection to the toolhead, but it’s wrapped with heatshrink to avoid it coming loose Yours looks better for this purpose!

43 replies

RRCRat Rig Community [Unofficial]

•Created by DOAmatrix on 1/11/2024 in #ratos-support

4 pin Fan cant be controlled

I'm using regular 4 pin fan connectors, as used in PCs. Thats what the socket is made for. Got mine from here, but they might even be included in the Max EZ accessories? https://www.cable-sleeving.com/4-pin-fan-connector

43 replies

RRCRat Rig Community [Unofficial]

•Created by DOAmatrix on 1/11/2024 in #ratos-support

4 pin Fan cant be controlled