plutonasa
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 10/31/2024 in #ratos-support
Not understanding VAOC calibration
👍 alright, I'll check my tensions again. Thanks!
13 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 10/31/2024 in #ratos-support
Not understanding VAOC calibration
is there no need to "make sure" the other tool is aligned?
13 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 10/31/2024 in #ratos-support
Not understanding VAOC calibration
I appreciate the response, will take a look into that
13 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 9/27/2024 in #fix-my-resonance
VC400 Hybrid belts kicking my butt and taking my lunch money
9 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 9/27/2024 in #fix-my-resonance
VC400 Hybrid belts kicking my butt and taking my lunch money
9 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 9/27/2024 in #fix-my-resonance
VC400 Hybrid belts kicking my butt and taking my lunch money
Before this, I also rebelted the whole machine, made sure the belt lengths are as equal and ran as equal as I can get them.
9 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 9/27/2024 in #fix-my-resonance
VC400 Hybrid belts kicking my butt and taking my lunch money
I also don't really have a reference for what is too tight or too loose for the hybrid belts.
9 replies
RRCRat Rig Community [Unofficial]
•Created by plutonasa on 9/27/2024 in #fix-my-resonance
VC400 Hybrid belts kicking my butt and taking my lunch money
not really too sure how to quantify, don't have anything to measure the torque. I take my thumb and index on the allen key and turn the screw until I can't turn it anymore. The belts are taut, but aren't overtightened. I tried to tighten the right belt to way more than feels safe, but the spike won't merge. The right belt at that point feels rigid.
9 replies
RRCRat Rig Community [Unofficial]
•Created by mazas on 8/2/2024 in #fix-my-mesh
VC4 400 Both back corners dip
@VisualTech48 followed your suggestions in this thread and got a bed mesh to under .12mm range when heated to 60 C on my 400mm vc4. Thanks! My question to you is how can we guarantee the x gantry to stay like this? I would assume it is expected that the x gantry will sag over time and we just yank on it when needed. Not to mention potential expansion when enclosed. I saw you mention something about screwing and unscrewing the x gantry when it is hot, but I don't think I fully understand.
204 replies