SithMaster015
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 11/5/2024 in #fix-my-print
PETG Problems
10 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 8/31/2024 in #fix-my-printer
Print randomly stops
15 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 8/26/2024 in #fix-my-print
extrusion issues
6 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 6/18/2024 in #fix-my-printer
klipper suddenly stopped
1 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 6/14/2024 in #fix-my-print
Extrusion inconsistencies
5 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 5/24/2024 in #fix-my-printer
Temp reading is wrong?
So my 3.1 printer committed suicide the other day and I came hone to the glob of Death. My extruder could not be saved so I decided to take the opportunity to upgrade to the BETA2 tool head. Now that I'm finished putting it together, I finally fired up the printer and Klipper and my extruder temp is reading 158° despite having not even tried to heat up my hot end. Before noticing this, I tried to heat it up and got a shutdown due to "extruder not heating at expected rate." But my hot end is cold to the touch, yet still reads this high temp. Any idea what I did wrong?
19 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 1/16/2024 in #fix-my-printer
Probable jam
Had an issue today when trying to change filament rolls mid-print. Paused my printer and had it eject the spool that was almost out for my new one. Problem is, when I went to put the new one in, it wouldn't go through. I think it got stuck somewhere in the heat break, and nothing I've tried has yielded any results. Tried poking around with acupuncture needles, pushing through with another filament, cranked up my temp in hopes it would liquefy anything around the nozzle. Nothing works. Is it most likely some filament that caked into my heat break and got stuck there? If so how do I go about fixing this? Is it maybe something else?
2 replies
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 8/1/2023 in #fix-my-printer
Z Tilt error help
9 replies