Supercrossed
Supercrossed
RRCRat Rig Community [Unofficial]
Created by Supercrossed on 8/17/2024 in #fix-my-print
vcore 3.1 PACF woes
No description
8 replies
RRCRat Rig Community [Unofficial]
Created by Supercrossed on 7/1/2024 in #fix-my-print
UHF Oozing
I have a rapido 2f with the UHF nut. Previously was using the original rapido, HF with a v6. With PLA, the prints are perfect, but with 'oozier' filaments, like CFPC, or LWPLA, the stringing is a nightmare. I've done all the regular tuning, but my question is do UHF/Volcano hotends require more retraction than compared to non UHF nozzles? To get more filament out of the melt zone? Is there anything else I should be considering? Like retraction length vs retraction speed.
3 replies
RRCRat Rig Community [Unofficial]
Created by Supercrossed on 6/15/2024 in #fix-my-resonance
Opinion on these graphs
No description
20 replies
RRCRat Rig Community [Unofficial]
Created by Supercrossed on 6/14/2024 in #fix-my-print
extrusion issues
No description
22 replies
RRCRat Rig Community [Unofficial]
Created by Supercrossed on 6/20/2023 in #fix-my-printer
Sudden bad extruder stepper
My LGX is no longer working, it is on an skr octopus, with tmc 2290s. The stepper is just grinding, like when the wires are backwards. I've tried swapping in a new stepper but it is still grinding. Could it be the wiring? The motor itself? I've also tried a different stepper port on the octopus.
4 replies