umop3plsdn3dlus
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 7/31/2023 in #fix-my-print
Settings change mid brim?
393 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 7/26/2023 in #fix-my-printer
Heated Bed Edges?
Anyone else run into ASA prints warping because the bed doesn't hold temp edge to edge? Using all of my bed on the 300, couldn't figure out why it keeps warping. Laser thermo says ~25c drop in temp at the edges of the bed where my warps keep happening. Does someone make a bed heater for the 300 that goes edge to edge? Or am I asking too much of this printer?
36 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 7/26/2023 in #fix-my-print
Heated Bed to edges?
Anyone else run into ASA prints warping because the bed doesn't hold temp edge to edge? Using all of my bed on the 300, couldn't figure out why it keeps warping. Laser thermo says ~25c drop in temp at the edges of the bed where my warps keep happening. Does someone make a bed heater for the 300 that goes edge to edge? Or am I asking too much of this printer?
1 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 7/21/2023 in #fix-my-printer
Having assorted issues, nuke?
What's the easiest way to just nuke RatOS? Complete reinstall? Or if I delete all the configs, will it just auto generated new one? Ive got some assorted issues that I can't track down, and at this point I can't remember what has/hasn't been changed. I think it'll probably be easier with a blank slate and start from there instead.
2 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 7/7/2023 in #fix-my-printer
Rapido Heatbreak
14 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 5/11/2023 in #fix-my-print
lifting?
6 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 3/20/2023 in #ratos-support
Turn on Fan Port.
If I wanted to add another fan for the BTT octopus in RatOS/Klipper, how would I go about turning on that fan port?
Is it just
enable_pin: x in user overrides in printer.cfg?
Google isn't helping me much20 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 3/16/2023 in #ratos-support
4028 Pin name
36 replies
RRCRat Rig Community [Unofficial]
•Created by umop3plsdn3dlus on 3/15/2023 in #ratos-support
RatOS, Open Network
I tried searching but didn't see anything.
Can I not put RatOS on a wifi network with no password? On the configuration page it requires 8 characters, even though this wifi is open.
46 replies