Lance
RRCRat Rig Community [Unofficial]
•Created by Lance on 1/3/2025 in #ratos-support
Update crash
3 replies
RRCRat Rig Community [Unofficial]
•Created by Lance on 1/3/2025 in #fix-my-printer
Update crash
3 replies
RRCRat Rig Community [Unofficial]
•Created by Lance on 12/26/2024 in #fix-my-printer
Installing KlipperScreen
Hello, I am trying to install a 7 inch LCD display as my clipper screen. Whenever I attach it via HDMI to my raspberry pie, it says no signal I’ve not changed any of the config. What do I need to change to make it work?
4 replies
RRCRat Rig Community [Unofficial]
•Created by Lance on 12/12/2024 in #fix-my-mesh
Adaptive mesh every print
Hello, is my printer supposed to adaptive bed mesh before every print? If not how do I stop it from doing so?
3 replies
RRCRat Rig Community [Unofficial]
•Created by Lance on 12/7/2024 in #fix-my-printer
Back Z Motor error
Hello, my issue is when I home the Z axis the front two motors go up like they’re supposed to, but while the back Z motor goes down. When I go up or down after setting the kinematic zero, all three are going in the right direction. Any help would be greatly appreciated!
12 replies
RRCRat Rig Community [Unofficial]
•Created by Lance on 11/24/2024 in #fix-my-printer
Octopus v1.1 not detecting
12 replies
RRCRat Rig Community [Unofficial]
•Created by Lance on 11/22/2024 in #ratos-support
Setup step 1 issues
Hello, I am having some issues setting up RatOS. It’s my first time using it and I don’t know what I’m doing wrong. I am in the setup page and when I try to update/ download the firmware and move to the next step, it won’t let me. It is says board not detected. But it has auto flashed before. I checked the firmware file and it is .cur file so I know it did it right. Can I just skip the rest of the set up and go to mainsail and add my stuff. I am also getting a mcu error on mainsail. Any help would be appreciated.
88 replies