Manual stepper motor issues
Hello, I am trying to add a manual stepper motor to my V3.1 for a simple multi material unit, and I cannot seem to get the motor to turn. I have switched the wires around on the motor and now the motor locks up when connected to power. I have attached my configuration for it. I’m using an octopus V1.1 with a TMC 2209 driver and slot one. Any help would be greatly appreciated.
1 Reply
If it locks but doesnt turn, enable_pin is correct, verify the step_pin being wired correctly
Pinout is correct for slot 1
Did you perhaps put the tmc in the wrong slot? As the first slot is slot 0?
Maybe you can also pull up the klipper config and verify the motor with "stepper buzz" or "force move" commands