Lance Comments - Answer Overflow

Lance

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/26/2024 in #fix-my-printer

Installing KlipperScreen

With a secondary power supply

4 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/7/2024 in #fix-my-printer

Back Z Motor error

I accidentally swapped drivers. The x and y shit happened on both old and new boards. So the x and y drivers are in the back and right z slots. I will try and move the z slot and try a new driver when I get home

12 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/7/2024 in #fix-my-printer

Back Z Motor error

What about the stepper drivers

12 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/7/2024 in #fix-my-printer

Back Z Motor error

It’s a brand new board

12 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/7/2024 in #fix-my-printer

Back Z Motor error

@miklschmidt would you happen to know what is happening or should I go through it like my x and y motors?

12 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 11/24/2024 in #fix-my-printer

Octopus v1.1 not detecting

Yes

12 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/7/2024 in #fix-my-printer

Back Z Motor error

The coupler is tight

12 replies

RRCRat Rig Community [Unofficial]

•Created by Lance on 12/7/2024 in #fix-my-printer

Back Z Motor error

I think it might be a bad stepper driver.

12 replies

RRCRat Rig Community [Unofficial]