BlueDun
BlueDun
RRCRat Rig Community [Unofficial]
Created by BlueDun on 10/26/2024 in #german-support
Orca SLicer Fan Settings - nix verstehn ...
Ich blick bei den fan settings immer noch nicht durch. Min fan speed sthreshold ... max fan speed threshold ... In Super Slicer war das einfacher Gibt's da irgendwo eine Doku für Schwerbegriffliche wie mich ??
2 replies
RRCRat Rig Community [Unofficial]
Created by BlueDun on 10/19/2024 in #ratos-support
Switching to performance mode -> z-tilt screws up
Upgraded to 3.1, toolhead and beacon With Mikkels help (thanks👍 ) I managed to set my three z-tilt probe points manually to suitable coordinates. After continuing with further commissioning and tuning, I finally came to the point where I switched to performance mode. I used the configurator to do that ( still not so familiar RatOS2.x). That completely screws up my z-tilt motion. Toolhead moves to weird positions and even bumps into limits - eg. in the front. So I tried a manual approach by adding to printer.cfg: [printer] max_velocity: 800 max_accel: 10000 minimum_cruise_ratio: 0.5 max_z_velocity: 50 max_z_accel: 600 square_corner_velocity: 5 [gcode_macro RatOS] variable_macro_travel_speed: 600 variable_macro_travel_accel: 8000 [bed_mesh] speed: 600 [z_tilt] speed: 600 Same problem. Z-tilt goes haywire with printhead all over the place. So how can I switch my 3.1 on RatOS2.1.0-RC3 to performance mode?
55 replies
RRCRat Rig Community [Unofficial]
Created by BlueDun on 10/18/2024 in #fix-my-mesh
Brute force as last resort?
No description
12 replies
RRCRat Rig Community [Unofficial]
Created by BlueDun on 10/17/2024 in #fix-my-printer
Part cooling fan issues after printer upgrade
No description
12 replies
RRCRat Rig Community [Unofficial]
Created by BlueDun on 10/16/2024 in #ratos-support
Probe points offset - unaffected by beacon x/y offset override
I just finished my 3.1 upgrade including a beacon probe. I'm currently running through the initial configuration. I noticed the 3 probe points used for z-tilt adjustment are shifted backward by several centimeters so that the probe point in the back is such that the beacon hangs halfway off the printbed. First, i checked my 0,0 point and that is where it needs to be. I didn't want to touch the kinematics variables since it's a stock V-core. So I added a beacon section to my user overrides in the printer.cfg: [beacon] x_offset: 0
y_offset: 22.5 I started playing with the y_offset and strangely, this does not seem to change anything. No matter what value I assign to y_offset, the position of the probe points remain unchanged. Puzzled right now ... Why could that be, what am I missing? And second, is that the right approch to correct for the "probe point triangle" shifted to the back? Version is RatOS-v2.1.0-RC3
10 replies