Sjef Romijn
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 7/18/2023 in #fix-my-print
~21mm wobble/error in print?
7 replies
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 7/11/2023 in #fix-my-printer
Frame or other?
1 replies
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 6/15/2023 in #fix-my-print
is this the extruder doing?
4 replies
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 5/28/2023 in #ratos-support
Unable to read tmc uart 'extruder' register IFCNT
a. I had a FLY-SHT36, working, but was missing a few connectors, so removed it
b. ran the toolhead and thus extruder via direct wires on the Octopus v1.1, so installed 2209 stepper, working
c. removed the stepper on the octopus, installed an EBB-42 but get this error when wanting to run the extruder
fans, thermistor, Euclid etc all runs fine, see attached klippylog and printer.cfg if you can see anything odd?
34 replies