SrTKid24
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 1/18/2025 in #ratos-support
How do i fix this?
Thank you!
12 replies
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 1/18/2025 in #ratos-support
How do i fix this?
That fixed it!
12 replies
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 1/18/2025 in #ratos-support
How do i fix this?
didnt know if there was an easier fix than redoing everything
12 replies
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 1/18/2025 in #ratos-support
How do i fix this?
sd card is about 1 month old humm not sure scandisk i believe. I guess i could take it out and reflash with ratos
12 replies
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 1/18/2025 in #ratos-support
How do i fix this?
12 replies
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 1/18/2025 in #ratos-support
How do i fix this?
yes i always shutdown PI first than wait a few minutes before shutting power off at printer
12 replies
RRCRat Rig Community [Unofficial]
•Created by SrTKid24 on 6/20/2024 in #fix-my-mesh
Vcore 500 bed mesh
Thank you for all the info! I will do as you suggested and see if it make it better. its a vcore 3.1.
9 replies
RRCRat Rig Community [Unofficial]
•Created by genetic-orange on 4/5/2023 in #fix-my-print
lifting first layer
Lower z height
4 replies