lifting first layer

First layer lifts as it's put down. If i can make it up a couple layers then no problem. Pla Bed @70. Nozzle @ 200
No description
3 Replies
adverse-sapphire
adverse-sapphire3y ago
Way too tight firstlayer squishy
SrTKid24
SrTKid243y ago
Lower z height
conscious-sapphire
conscious-sapphire3y ago
I had the same issue with my CR10S Pro with PLA. Turned out my z offset had changed at some point so when I dialled it in correctly again it was perfect. Mine was slightly too high. I don’t know if you use Klipper or not, I do with mainsail & I just babystepped it on a test print until it didn’t do that. Had to redo my mesh afterwards but it’s been fine since. If you’ve not already tried this I’d do it first as it’s most likely cause.

Did you find this page helpful?