omerk83

PostsComments

RRCRat Rig Community [Unofficial]

•Created by omerk83 on 12/15/2024 in #fix-my-print

Print layer shift effect with no layer shift

4 replies

RRCRat Rig Community [Unofficial]

•Created by omerk83 on 10/7/2024 in #fix-my-resonance

vc4 300 hybrid input shaper

4 replies

RRCRat Rig Community [Unofficial]

•Created by omerk83 on 10/3/2024 in #fix-my-resonance

VC4 300 Hybrid belt tension

1 replies

RRCRat Rig Community [Unofficial]

•Created by omerk83 on 9/25/2024 in #ratos-support

RatOS wizard problems

Hi, I started the install wizard with RatOS-v2.0.2, I have Raspberry Pi 4 and Octopus v1.1. The Wi-Fi connected without a problem, but I can't flash the board with the USB-C cable. I read here that I should use RatOS-v2.1.0-RC2. I updated it to this version, and now I can't connect to the wifi or flash the board. How can I solve this? I really don't want to buy a new SD card just to flash the board. Any ideas on how to solve it? Thanks Update: I flashed RatOS-v2.1.0-RC2 with Balena Etcher 18.0 and the wifi connected, however, the octopus v1.1 still can't flash automatically or with the DFU with the error: "Status: DFU not detected"

44 replies

RRCRat Rig Community [Unofficial]

•Created by omerk83 on 7/18/2024 in #ratos-support

BIGTREETECH Pi 2 with RatOS

Hi, did anyone try to use the new BIGTREETECH Pi 2 to run RatOS? I see its noe in the supprted bordes and I wondered if anyone had any luck. Thanks!

4 replies