fredz
RRCRat Rig Community [Unofficial]
•Created by fredz on 2/25/2025 in #fix-my-printer
prusa mini- klipper error
Hi everybody... I have a issue with klipper.... I would like to use my prusa mini with ratos... motherboard flashed... all done without any problem but I have a klipper error in main sail
I check the printer config file and ratos.cfg but didn't find the problem
Did somebody have this issue?
57 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 2/22/2025 in #ratos-support
RatOs invalide
60 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 5/1/2024 in #ratos-support
RatOs doesn’t see my spider v1.1
20 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 3/14/2024 in #ratos-support
v-minion sensorless homing
Hi,
I still have problem to configure sensorless homing on my v-minion.
then I resume what I did and what I have as problems. 1° I put the jumper for homing under x and y drivers as it is noticed in the Btt skrat documentation. 2° As It is noticed in Ratos printer.cfg I copied the sensorless-homing-tmc2209 in the root and uncomment [include sensorless-homing-tmc2209.cfg] in the printer.cfg 3° put driver_SGTHRS to 255 and start first homing... normally It must not move at all and on my side the carriage go to end and don't stop at all.... I have to make a emergency stop. I don't know what's wrong
20 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 2/23/2024 in #ratos-support
nevermore filter control
I just installed a nevermore filter in my enclosure and would like to start it and stop it with the gcode start and gcode end.
I m using skrat mainboard with RatOs.
My questions is how to do?
What do I have to write in my printer.cfg and in my gcode. Thanks for help.
2 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 1/20/2024 in #ratos-support
klipper_tmc_autotune
Is RatOs is working with klipper TMC autotune?
18 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 12/28/2023 in #ratos-support
cannot upload print to RatOs
3 replies
RRCRat Rig Community [Unofficial]
•Created by fredz on 12/15/2023 in #ratos-support
connection failed
Hi, during printing I always have connection problem with RatOs. I must actualize 2or3 Times before restore it. What can I do?
2 replies