soap
RRCRat Rig Community [Unofficial]
•Created by soap on 2/2/2025 in #fix-my-mesh
Vcore 3.1 400 after beacon configuration
10 replies
RRCRat Rig Community [Unofficial]
•Created by soap on 1/12/2025 in #ratos-support
Changes to Start_Print and End_Print
Hi, I would like to know what and how to make changes to G-code or printer config in order to accomplish a few things:
1) In End Print: keep bed heater on x amount of minutes after the print is finished. I often will start a print after one ends and have to reset the bed temp to make sure it's not losing heat before the next print.
2) In Start Print: Do not turn the hot end down to 150C prior to print if it is already at a higher temp (i.e. from a filament change between prints).
Here is what I have in my slicer (as per the RR instructions when I first configured the printer):
START_PRINT EXTRUDER_TEMP=[nozzle_temperature_initial_layer] BED_TEMP=[bed_temperature_initial_layer_single]
2 replies
RRCRat Rig Community [Unofficial]
•Created by soap on 9/16/2024 in #fix-my-print
Flow Issues?
29 replies