PSnewbie Comments - Answer Overflow

PSnewbie

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by PSnewbie on 12/7/2023 in #fix-my-mesh

Enclosed v3.1 400 bed mesh advice

16 replies

RRCRat Rig Community [Unofficial]

•Created by PSnewbie on 12/7/2023 in #fix-my-mesh

Enclosed v3.1 400 bed mesh advice

I took my bed to work, put it in an industrial drier at 80°C for 20 min and polished it on a calibrated surface plate, check flatness with a FARO Quantum Max, rinse and repeat. Edit: The rear left corner is raised from the build surface being damaged during shipping, no big deal to me, and the rest is probably due to the magnetic sheet being inconsistent, but there's nothing I can do about that.

16 replies

RRCRat Rig Community [Unofficial]

•Created by PSnewbie on 12/7/2023 in #fix-my-mesh

Enclosed v3.1 400 bed mesh advice

16 replies

RRCRat Rig Community [Unofficial]

•Created by Outsider on 1/20/2024 in #fix-my-print

surface stramgeness

I had a few benchies with a similar artifact problem on the front like that. My problem was a simple fix. I over compensated the hot end temp to the speed I was printing at. I lowered the temp 10 degrees and it went away. The higher temp didn't show any problems anywhere else on the print, just around the bow.

10 replies

RRCRat Rig Community [Unofficial]

•Created by Lemcott on 12/11/2023 in #fix-my-mesh

400mm 3.1 mesh

The advice given to me was to get your deviation below 0.2 high to low. According to this your almost 9 times out from that

135 replies

RRCRat Rig Community [Unofficial]

•Created by Lemcott on 12/11/2023 in #fix-my-mesh

400mm 3.1 mesh

Am I reading that wrong? The deciation looks like 1.7ish to me. High is 1.65, low is -0.07.

135 replies

RRCRat Rig Community [Unofficial]