YouvBeenThumped
RRCRat Rig Community [Unofficial]
•Created by YouvBeenThumped on 5/30/2024 in #fix-my-printer
Super Power motors on 5160 Pro's 48V
So switched out the Speedy Powers for Super Powers on 48v and now my Printer does this.
Obviously The config file for the 2504AC is not compatible with the 2804AH motors.
Any pointers would be appreciated
4 replies
RRCRat Rig Community [Unofficial]
•Created by YouvBeenThumped on 5/4/2024 in #fix-my-printer
MCU Not connecting. Klipper Log provided. After swapping from Octopus V1.1 to Pro h723 V1.1
18 replies
RRCRat Rig Community [Unofficial]
•Created by YouvBeenThumped on 4/18/2024 in #fix-my-print
kind of at a loss
3 replies
RRCRat Rig Community [Unofficial]
•Created by YouvBeenThumped on 3/30/2024 in #fix-my-printer
Belt tension or something else?
10 replies
RRCRat Rig Community [Unofficial]
•Created by YouvBeenThumped on 3/17/2024 in #ratos-support
PT1000 Thermistor setup.
Trying to understand using a PT1000 Thermistor but between the RatOS install guide and the EBB36 V1.2 manual. I am conflicted on if I should be using the same pins as the standard NTC104 thermistor or the ones connected to the MAX 31865 chip.
9 replies
RRCRat Rig Community [Unofficial]
•Created by YouvBeenThumped on 3/2/2024 in #ratos-support
Fresh RatOS install x2 and still can't get the MCU to respond
Have installed RatOS x2 today, Have a brand new Octopus V1.1 flashed via sd card, and tried flashing it through RatOS a few times and the Configurator keeps telling me Octopus V1.1 Detected but is unresponsive. Not sure what else to do other than do the whole thing through SSH like usual.
36 replies