MCU Not connecting. Klipper Log provided. After swapping from Octopus V1.1 to Pro h723 V1.1
Getting a connecting issue with no error code. But the log is showing that no File or Directory for Pro V1.1 is found. Not really sure what is going on to cause this. Board flashed and shows up under usb devices. Changed the board option in Printer.cfg
Solution:
Jump to solution
WTF.... How does that actually work @miklschmidt Sorry for the Ping.. But I'd like to understand this for if I am helping someone else...
12 Replies
Here is the Printer.cfg as well.
So I had some oddities flashing my Pro h723 V1.1 that I got recently as well. I had to flash the firmware at least twice for it to show up correctly. It may be worth re flashing it as a suggestion.
ok
its at least a pretty fast thing to try and since we bought our boards around the same time, I think they are potentially from the same batch
Oh one thing I noticed is that you do not have a Steppers section in your includes. All three options are commented out
Line 41 is the section where it starts to be more precise on where to look
That is because I am not using the standard comments
AH woops sorry, should have gone although the way through first
It's all good
I tried reflashing and get the same issue
Solution
WTF.... How does that actually work @miklschmidt Sorry for the Ping.. But I'd like to understand this for if I am helping someone else...
@Hunterprime figured it out by just pissing in the wind :kekw: :GUNPEPE: :AngeryPing:
Wait really?
I have no clue why that works... Typically if I did that in the past with something else. It would error out about the alias