Jäärne
RRCRat Rig Community [Unofficial]
•Created by hhes on 10/15/2024 in #fix-my-print
External perimeter with no filament extruded after the seam and blobs everywhere
i would try first layer test just in case.
18 replies
RRCRat Rig Community [Unofficial]
•Created by hhes on 10/15/2024 in #fix-my-print
External perimeter with no filament extruded after the seam and blobs everywhere
i have had similiar issue also and nozzle change did the job. Try first layer test and look how it is.
18 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 10/15/2024 in #fix-my-print
z axis skipping
5 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 8/30/2024 in #fix-my-printer
hot end temperature extreme fluctuation
First of all sorry for the amount of messages. Issue solved: The cables of thermistor and especially the connector got pinched when print head did the -X movement from side of the table to start of the print after the prime blob. Moved the connector to the other side of the wiring harness and no issues anymore. Special Thanks for @TheTik .
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 8/30/2024 in #fix-my-printer
hot end temperature extreme fluctuation
for the 6th time I tried the wiggle test when hot end tried to reach first layer temp and got the temperature to fluctuate. I think you (TheTik) was right. I will tell you when I find the broken wire..
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 8/30/2024 in #fix-my-printer
hot end temperature extreme fluctuation
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 8/30/2024 in #fix-my-printer
hot end temperature extreme fluctuation
the fluctutation starts RIGHT when the print starts after prime blob. When layer counter resets the temp goes crazy
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 8/30/2024 in #fix-my-printer
hot end temperature extreme fluctuation
I think wiggle test is done. Came to same conclusion too and wiggled everything maybe 5 separate times with different hot end temperatures and no fluctuation.. Can it be slicer related? For me atleast the print shows constant temp when sliced..
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jäärne on 8/30/2024 in #fix-my-printer
hot end temperature extreme fluctuation
Minor update: I tried to print something small and since it survives the first layers the problem goes away..
11 replies
RRCRat Rig Community [Unofficial]
•Created by DOAmatrix on 5/27/2024 in #ratos-support
NetworkManager not working after update
Update: on my side I had the same messages, but the real problem was change on ip adress. From klipper screen - system, can be found the actual ip adress and after chancing that to the slicer device configuration everything started working. But still the messages are there in network status.
70 replies
RRCRat Rig Community [Unofficial]
•Created by DOAmatrix on 5/27/2024 in #ratos-support
NetworkManager not working after update
Same issue here after update
70 replies