Peabutt
RRCRat Rig Community [Unofficial]
•Created by Peabutt on 12/23/2024 in #fix-my-resonance
v4 idex 500 tuning
10 replies
RRCRat Rig Community [Unofficial]
•Created by Peabutt on 12/15/2024 in #fix-my-printer
V4 idex z offset issue
Hello,
I need some advise. Im getting terrible z offset cal, between 0.17 and 0.175. I have checked everything and disassembled both heads, twice. Also swapped nozzle, because why not.
I havent done what ratrig suggested, to use a shim as a last resort. But as far as i understand, this is only important if i use copy/mirror mode correct? For dual filament its ok? I dont think ill ever use copy/mirror mode. Should i bother to make it close to 0 as possible? What are the downsides of using a shim as a spacer?
39 replies