v4 idex 500 tuning
hello,
so ive been spending a lot, A LOT, of time trying to tune my printer and ive reached that point that im only getting things worse.
as far as i understand x axis are not so bad, could be better but... meh. but the y axis looks terrible.
looking for advice on what to do
7 Replies
Were you able to better your y-axis? Especially the 125hz peak on Y?
the more reasearch I do seems like IDEX is impossible to get good. There are just to many moving parts.
nop
i just have to print slower than i supposed to
but i havent as much as i would like to. hopefully ill have time again now
I have the same 125 hz hump on my machine but it ended up being the electronics enclosure back panel resonating
I already tried without the back panel without success
Litirally no change in the graph
Putting all my panels on removed that peak 🤷♂️ https://discord.com/channels/582187371529764864/1223286652949106748/1287397504341508098
Had my back panel on the whole time
i have all my panels on