lordgufi
RRCRat Rig Community [Unofficial]
•Created by lordgufi on 2/4/2025 in #ratos-support
Unable to set Enclosure heater temp after a print completes
If i set the temp it will be zero'd back out after a few seconds ( some times less ) the previous print had set enclosure temp to be off but the print is now finished and i need to heat the enclosure for the next print.
I'm not getting any errors, its as if it still thinks its printing, if i reset firmware i can set the enclosure temp to whatever i want like expected
START_PRINT (with expected params ) and END_PRINT exist in the Gcode
103 replies