Seam has consistent blob but not sure how to remove it

Machine: Core v4 500, toro tube and chube, 0.4 nozzle External walls printed at 150mm/s with scarf ASA material What i've noticed is that the printer will sit at the seam for a split second which causes a smidge of oozing. I'm not at all sure what is causing it to sit at the seam but past that all other paramters appear great. the finish is good, layers are smooth. dimensions are within acceptable range for holes. I havn't played with retraction settings because when i did a retraction test it was fine above the 3rd "rung" ( orca test ) which would be 0.6 where its having issue but at 0.8 ( current setting ) there was no issue. Most notably this happens on circles, if its a long line I dont seem to have as much if at all noticeable on the print.
2 Replies
lordgufi
lordgufiOP2w ago
No description
lordgufi
lordgufiOP2w ago
well oddly enough it ended up being having Wipe on loops turned on. not sure when i turned that on

Did you find this page helpful?