Luggi
Luggi
RRCRat Rig Community [Unofficial]
Created by Luggi on 4/14/2025 in #fix-my-print
All Prints too small in Z
All my Prints are too small Z. A 50x50x20mm part comes out as 50,05x50,05x19,45. I use Orcaslicer but i already tried Prusaslicer for a while (without any success) The printer has 0.6mm nozzles installed right now. I just redid beacon calibration again at 85c bed and 35c chamber. Same with VAOC Thermal Expansion. I didnt touch z-offset because as far as i know thats the point of beacon contact? Frist layer is ok but it a bit on the high side so there is some gaps. All other solid layers are filled perfectly. Any ideas?
2 replies
RRCRat Rig Community [Unofficial]
Created by Luggi on 1/10/2025 in #fix-my-resonance
V-Core 4 500 IDEX Peak at 125hz
No description
14 replies
RRCRat Rig Community [Unofficial]
Created by Luggi on 11/29/2024 in #fix-my-resonance
VC4 500 Idex Belt Tension
No description
1 replies