Toro22
RRCRat Rig Community [Unofficial]
•Created by Toro22 on 9/24/2024 in #fix-my-print
Knocking hotend off track
9 replies
RRCRat Rig Community [Unofficial]
•Created by Toro22 on 9/19/2024 in #fix-my-mesh
Super Pinda, still leaves the first layer uneven on RatRig500
Test :
5 .25mm patches in center and corners
Bed: 80C for 30min plus
Probe: SuperPinda
The patches in the rear shows a hotend too far away, while the front are to squashed.
I run BED_MESH_CALIBRATE for every print
What can I do to fix this?
Thank you!
2 replies
RRCRat Rig Community [Unofficial]
•Created by Toro22 on 8/27/2024 in #ratos-support
Belt tension - starting point - Vcore 3.0 , with updated toolhead
What is a good starting tension for the belts ?
Like a bass guitar sting, or looser?
First time round I get squeaky sounds from the motor cages, and a unwillingness to move..
7 replies
RRCRat Rig Community [Unofficial]
•Created by Toro22 on 4/23/2024 in #ratos-support
Klipper reports SHUTDOWN : verify_heater. ##Urgent##
This error is driving me nuts. I have 4-5 models , printed to 10-20%
I have a 6-7 day print that I need urgent.
After 12-36 Hours this error appears.
*
"Klipper reports: SHUTDOWN
Heater extruder not heating at expected rate
See the 'verify_heater' section in docs/Config_Reference.md* "
Spec:
V-core 3
Octopus pro board
Phaetus Rapido HCT
Klipper updated
Sliced on OrcaPrint
I can see from the log that:
The first hours the extruder target and temp are all good. Then after a number of hours, the extruder is not reacting to the applied PWM signal. First by a few degrees, then finally 20-30 degrees, and failure.
(Log attached)
I have three likely culprits:
- Driver on Octopus pro
- Cable to heater
- Heater
Does anyone have experience ???
Ideas ??
Thank you ! This model is going on show early May
Tor
10 replies
RRCRat Rig Community [Unofficial]
•Created by Toro22 on 2/6/2024 in #fix-my-print
A disasterous bridge...
3 replies
RRCRat Rig Community [Unofficial]
•Created by Toro22 on 1/8/2023 in #ratos-support
Controller fan on Octopus Pro 446, config . Help please
Hi all
To increase print speed I have connected two fans to the OctoPro board.
I borrowed this code :
Controller fan control
[multi_pin controller_fan_pins]
pins: PD12, PD13
pins: PD12, PD13
[controller_fan control_fan]
Controller fan - FAN2 & FAN3
pin: multi_pin: controller_fan_pins
max_power: 1.0
kick_start_time: 0.5
stepper: extruder
But I get this error :
Klipper reports: ERROR
pin PD12 is an alias for fan_controller_board_pin
Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted
I am clearly messing with something that could be solved much simpler....
Thanks in advance
Thor
5 replies