armearme.
RRCRat Rig Community [Unofficial]
•Created by armearme. on 2/10/2025 in #fix-my-printer
VC4 Hybrid pauses at random ocasions after Orbiter 2 Smart Sensor was installed.
Hello! There are no error messages or other identifications that something is wrong, printer just pauses itself like the filament would be not present (green light is on), printhead is parked in the front of the machine.
I have assembled and configured it as per these instructions: https://docs.ratrig.com/v-core-4-0/orbiter-2-smart-sensor#Smart-Sensor_Build-Guide
Any ideas?
11 replies
RRCRat Rig Community [Unofficial]
•Created by armearme. on 11/14/2024 in #fix-my-printer
Bed compensation is not working
Hello! I have noticed the after I start the print job, bed compensation is not activated. I am using a S3D slicer, I have copied and pasted start and end scripts from ratrig page. Is this something missing in start script o something is wrong in the printer's config files?
41 replies
RRCRat Rig Community [Unofficial]
•Created by armearme. on 11/13/2024 in #ratos-support
Communication timeout
Hi all! Are there any other reasons why "communication timeout" error occur other than bad USB cable or bad USB connection?
1 replies
RRCRat Rig Community [Unofficial]
•Created by armearme. on 11/3/2024 in #fix-my-print
uneven walls.
3 replies
RRCRat Rig Community [Unofficial]
•Created by armearme. on 10/31/2024 in #ratos-support
MCU shutdown: timer too close - after I start a print (quite a heavy file)
114 replies
RRCRat Rig Community [Unofficial]
•Created by armearme. on 9/16/2024 in #ratos-support
RatOS initial setup and configuration
179 replies