HarshReality
RRCRat Rig Community [Unofficial]
•Created by HarshReality on 4/28/2024 in #fix-my-printer
Beacon (Again)
Ahh then that would be my problem.. I made the false assumption that there was some sort of ‘preconfigured magic’ as there was with all the other hardware. It seems I’ll still need to add the z endstop variables etc to my printer config
5 replies
RRCRat Rig Community [Unofficial]
•Created by Plynix on 8/3/2023 in #ratos-support
Orbiter on Ocotopus v1.1
6 replies
RRCRat Rig Community [Unofficial]
•Created by Martijn Janssen on 7/24/2023 in #ratos-support
Repo has untracked source files
Where is this checked?
24 replies
RRCRat Rig Community [Unofficial]
•Created by SteveBorough on 5/24/2023 in #fix-my-mesh
Cant get this corner down
I was told.. .5 on a 500 was anacceptable range so my .2 on a 400 was wonderful
17 replies
RRCRat Rig Community [Unofficial]
•Created by SteveBorough on 5/24/2023 in #fix-my-mesh
Cant get this corner down
I played that game alot today.. What I ended up doing was in addition to the 3 corner brace screws to shift things I also took the mounting brackets to the electronics panel loose and then snugged them back after adjusting. In your case it looks as if the left rear needs to be raised a bit. Overall I played for an hour and got mine to a .23 variance.
17 replies
RRCRat Rig Community [Unofficial]
•Created by wee-brown on 4/15/2023 in #ratos-support
MCU Error in Mainsail - cant connect to mcu
Yea got this.. I replaced the endstops. Today I pressed the updates klipper etc. and now for some reason my Pi takes off and chokes. Yes, I can put a sink on it, or a fan on it.. but the temps climb almost uncontrolably. Im thinking of just going back ot a previous image and then ignoring updates LOL
60 replies
RRCRat Rig Community [Unofficial]
•Created by harsh-harlequin on 4/15/2023 in #ratos-support
MCU Error in Mainsail - cant connect to mcu
Endstops are RR 400 kit stock. Wiring is verified problem remains. Board changed and problem remains the only variable left are the endstops themselves
60 replies
RRCRat Rig Community [Unofficial]
•Created by ambitious-aqua on 4/15/2023 in #ratos-support
MCU Error in Mainsail - cant connect to mcu
Well. same old story really (and I found the aliases for the octo 1.1 to confirm) endstops are always triggered. Ohm switches, wires, I even purchased a new board. I find myself becoming a bit frustrated with the thing. Im sure I'll figure it out eventually just how much damage I do before then will be the question... well ,next will be replacing the switches themselves
60 replies
RRCRat Rig Community [Unofficial]
•Created by vicious-gold on 4/15/2023 in #ratos-support
MCU Error in Mainsail - cant connect to mcu
Just for my own curiosity.. on v-core 3.1.. wiring matches and connected to diag 0 & 1 where are the endstops in ratOS defined?
60 replies