K2theStank 🇨🇦
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/28/2025 in #fix-my-print
One color printing just slightly smaller on T1

2 replies
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/9/2025 in #fix-my-resonance
My Y belt tension seems unusual

2 replies
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/6/2025 in #fix-my-printer
Why is my Z-Tilt only hitting 2 of 3 corners
vCore 4 IDEX 400
When i first powered it up i had no issues and everything seemed good to go.
now it will home no issues,
park the T1 and move T0 to the front left,
moves T0 to the back middle,
when it goes to move T0 to the top right the T1 motor makes a sound hits the gantry then the T0 takes off the the middle left.
I've done all the sanity checks and the movements are exactly as they should be when you ask them to move, and the belts aren't overly tight to give any resistance i have a BIQU tensioner and have them all set to -4.6mm which seemed to be fine for all my other machines.
I'm super confused as it wasn't doing this until now and only does it on the Z-Tilt
17 replies