Sharpplayer96
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 1/11/2024 in #fix-my-printer
Loud buzzing sound coming from toolhead
Oof, not sure how much faster I can push printing PETG on this setup...
8 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 1/11/2024 in #fix-my-printer
Loud buzzing sound coming from toolhead
Seems to, yup!!!
Wow, have not tried that yet but it's definitely quieter (bumped up the speed factor to 120%).
So what does that mean? some kind of resonant speed?
8 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 1/11/2024 in #fix-my-printer
Loud buzzing sound coming from toolhead
8 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 7/25/2023 in #ratos-support
Adaptive Mesh not working
Thanks!
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 7/25/2023 in #ratos-support
Adaptive Mesh not working
Oof, alright
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 7/25/2023 in #ratos-support
Adaptive Mesh not working
Oh, well that could do it. Is there an instruction page on how to upgrade?
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 7/25/2023 in #ratos-support
Adaptive Mesh not working
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 7/25/2023 in #ratos-support
Adaptive Mesh not working
15 replies
RRCRat Rig Community [Unofficial]
•Created by adverse-sapphire on 7/7/2023 in #fix-my-print
Printed Parts
What's your extrusion multiplier? May be a slight over extrusion causing the dimensions to be slightly oversized but all the holes and belt gaps to be under sized. That's the issue I had with PETG parts (had the opposite issue when I reprinted in ASA)
13 replies
RRCRat Rig Community [Unofficial]
•Created by Kyle59 on 7/2/2023 in #fix-my-print
Not sure what is causing this.....
I don't want to steer you in the wrong direction but this looks like a hardware issue to me and not directly slicer related since it's only happening on one side.
My first 3 guesses would be uneven cooling, belt issue (potentially some dirt/debris on the belt), or a partially clogged/misaligned nozzle which could cause over extrusion in one direction.
What if you rotate the benchy 90 degrees and/or 180 degrees. See if it appears on the same physical side of the benchy or if it happens in the same direction relative to the printer (i.e. always appears toward the front or back of the printer) if it does change with the orientation of the benchy and not the printer then might be a slicer issue.
2 replies
RRCRat Rig Community [Unofficial]
•Created by Sharpplayer96 on 12/29/2022 in #fix-my-printer
Y-endstop Not Close Enough
Nevermind... I'm very dumb. I've been running my V-core 3.0 for almost a year without realising the little rubber bumpers on the rails should be removed.
That's what it was bottoming out on 🙃
3 replies