renatojd2010
RRCRat Rig Community [Unofficial]
•Created by renatojd2010 on 8/27/2024 in #ratos-support
Feed rate on Z axis from toolhead tab in Mainsail locks up lead screws
Hello, ever since I moved to ROS 2.1 on my VCore3.1 I have had the issue were if I move the z axis via the Toolhead say down 150MM, the acceleration is such that the leadscrews lock up and start to grind. I have no problem if I enter a feed rate of about F500 or Even higher. But I have to do that manually in the console. Does anyone have any suggestions? Is there a config somewhere that I can change the default feed rate for the z axis? Is there a mechanical issue? Any help would be appreciated. Thank you in advance.
15 replies
RRCRat Rig Community [Unofficial]
•Created by renatojd2010 on 7/24/2024 in #ratos-support
Getting Incomplete Slicer Configuration detected
Incomplete Slicer Configuration detected
Your slicer gcode settings are not up to date.
Learn more about the RatOS 2.1 Slicer Configuration
I copied and pasted the Cura specific slicer settings, but I still get this error message. Anyone know why. Also, shouldn't the skew profile also be in the printer settings in Cura?
23 replies
RRCRat Rig Community [Unofficial]
•Created by renatojd2010 on 8/30/2023 in #fix-my-mesh
Good after rebuilding VC3 400
2 replies
RRCRat Rig Community [Unofficial]
•Created by renatojd2010 on 8/1/2023 in #fix-my-mesh
New Plate is not flat
3 replies
RRCRat Rig Community [Unofficial]
•Created by renatojd2010 on 12/19/2022 in #fix-my-mesh
Need advise on how to fix this mesh
7 replies