babendums
RRCRat Rig Community [Unofficial]
•Created by babendums on 2/8/2025 in #fix-my-resonance
error trying to run shaper
Error on 'M204': S must be above 0.0, something changed, and i can't figure out why it keeps throwing this error when im trying to test my resonances.
6 replies
RRCRat Rig Community [Unofficial]
•Created by babendums on 2/23/2023 in #fix-my-printer
Setup tcm5160 drivers for X and Y but getting global scaler error
tmc spi 'stepper_x' register GLOBALSCALER
[tmc5160 stepper_x]
run_current: 2.0
cs_pin: PC4
spi_software_sclk_pin: PA5
spi_software_miso_pin: PA6
spi_software_mosi_pin: PA7
#hold_current: 1
2 replies
RRCRat Rig Community [Unofficial]
•Created by babendums on 2/5/2023 in #fix-my-print
Disconnected infill, grid, triangle, cubic.
1 replies
RRCRat Rig Community [Unofficial]
•Created by babendums on 2/4/2023 in #fix-my-print
what is this vertical banding
23 replies
RRCRat Rig Community [Unofficial]
•Created by babendums on 2/3/2023 in #fix-my-resonance
belt tension result
1 replies
RRCRat Rig Community [Unofficial]
•Created by babendums on 1/29/2023 in #ratos-support
Ebb36 Pt1000 temperature incorrect
Hello, when I use my PT1000 (verified good), sensor with Ebb36 TH0 port and pt1000 jumper I get 130C when it should be 20c. When i connect to the 4pin connector (2 middle pins and dipswitches set for 2wire pt1000), i get ADC out of range. I have no overrides set. any help would be appreciated.
15 replies
RRCRat Rig Community [Unofficial]
•Created by babendums on 1/16/2023 in #ratos-support
Octopus Pro not detected, SSH not working on ALPHA5 (64bit on RP4)
6 replies