Octopus Pro not detected, SSH not working on ALPHA5 (64bit on RP4)
My Octopus Pro F446 board is not showing up in the config, I have set this up before with normal klipper/mainsail, so i know the board is good. The RatOS configurator is not able to find it however.
5 Replies
magic-amberOP•2y ago
I can't even SSH to it because I am getting some weird error. I can WinSCP to it thats about it:
correct-apricot•2y ago
I had the problem with RatOS not being able to detect my octopus pro 446 board. But this was due to flashing the motherboard directly from Klipper using SSH. After flashing the RatOS firmware to the board, it was detected. Did you follow the guide, flashing using SD card? And are your jumpers set for that type of flashing?
You have to delete the old key associated with the alpha 4 install.
magic-amberOP•2y ago
Nah none of these are it, it was a fresh install
I'm gonna close this, as this is a known issue.