lost
RRCRat Rig Community [Unofficial]
•Created by lost on 11/20/2024 in #fix-my-printer
Extruder Temp Reading Very High
129 replies
RRCRat Rig Community [Unofficial]
•Created by lost on 9/27/2023 in #fix-my-print
Extrusion issues after retraction
10 replies
RRCRat Rig Community [Unofficial]
•Created by lost on 7/26/2023 in #fix-my-mesh
Having trouble lowering a gantry corner? Protip: Use heat tape
If you're building a 500 and are dealing with one of the gantry corners not being low enough, but can't move it lower because it's blocked by an electronics panel extrusion, then use heat tape!
Simply place a little bit o heat tape (it'll add ~.4 mm) under the magnetic plate, and voila. The heat tape does a good job transferring heat, and it will raise your bed so you do not need to lower your gantry.
This helped me achieve <.25mm range on my 500.
HEre's some heat tape I like to use: https://www.amazon.com/gp/product/B08NY4914D/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
another pro tip: put it ON the bed with some glue on top to help larger prints stick to the bed and prevent warping.
1 replies
RRCRat Rig Community [Unofficial]
•Created by lost on 7/24/2023 in #fix-my-printer
My z-tilt seems skewed
1 replies
RRCRat Rig Community [Unofficial]
•Created by lost on 7/24/2023 in #ratos-support
Cannot find belt tension graph
5 replies
RRCRat Rig Community [Unofficial]
•Created by lost on 7/17/2023 in #fix-my-mesh
Any ideas on what to fix?
18 replies
RRCRat Rig Community [Unofficial]
•Created by lost on 7/12/2023 in #ratos-support
Where do I set fan speed on startup? What about while printing?
Whenever I boot my Vcore up the fan goes to max. Is there a setting in RatOS I need to toggle to tone it down a bit? Is there a value I can change to set its level while printing?
Thanks.
6 replies