Nebulator
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 7/1/2024 in #ratos-support
Logitec Brio webcam
Hm ok. Thanks, I'll see what I can do.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Lemcott on 12/11/2023 in #fix-my-mesh
400mm 3.1 mesh
Offtopic ... What about annealed parts? Does CF20 make it better (compared to CF10 of 15)? In your opinion what would be the best for this? I wanted to go for PA-CF because it was so much lighter than parts I printed in ASA. IIRC it was nearly half the weight.
135 replies
RRCRat Rig Community [Unofficial]
•Created by Lemcott on 12/11/2023 in #fix-my-mesh
400mm 3.1 mesh
Yeh I misread. It was 
135 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
Yeh I’ve been dealing with creep since I got this printer. It’s annoying af. All thermoplastics creep and nylon is maybe worse than abs or asa, I’m not sure. I do think cf20 makes it a little better? Either way not much choice. Will use heat inserts and use m3 washers where I can. They help a bit too. Im just hoping this will be better in terms of resonances. Spools are in the dryer again until I get home later today. That would be the second run of 10 hour drying.
35 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
35 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
I did have a little bit of stringing in another print as well. Next print will dry the spool some more
35 replies
RRCRat Rig Community [Unofficial]
•Created by Lemcott on 12/11/2023 in #fix-my-mesh
400mm 3.1 mesh
thats well within 0.2 deviation and is just fine. Im sure if you look at that peak that can be reduced as well. The dip in the middle can be bowing of the rail due to thermal expansion differences.
135 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
35 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
I;'ll try the fan
35 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
and prevent cross perims
35 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 12/16/2023 in #fix-my-print
Printing PA-CF
nah sounds good. I always do zhop
35 replies