funtimeerror Comments - Answer Overflow

i think the 125 spike here is due to my ebb toolhead wobbling a bit since its not braced by the orbiter, but it does show that the majority of the frequency spikes above 150hz go away

15 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 4/1/2025 in #fix-my-resonance

Swapped EVA -> RatRig toolhead and massive resonance spike

15 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 4/1/2025 in #fix-my-resonance

Swapped EVA -> RatRig toolhead and massive resonance spike

15 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 4/1/2025 in #fix-my-resonance

Swapped EVA -> RatRig toolhead and massive resonance spike

@OldKingHamlet i've pretty much came to the same conclusion. the orbiter seems to want to rattle when oscillating at around 40hz-50hz I did find a loose screw on my rapido that was rattling at high freqs.

15 replies

RRCRat Rig Community [Unofficial]

•Created by Roughneck on 9/20/2024 in #ratos-support

can ERCF v2 work on RATOS 2.1

RatOS is running klipper so I don’t see why it wouldn’t work. I’m ~1/2 thru my ercf v2 build for my vcore 3.1 300

4 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 5/2/2024 in #fix-my-printer

Best way to remove RTV glue from keenovo heater pad?

for follow up if anyone ever needs to do this, here is what I did. I soaked a paper towel in Rio Methyl Alcohol and laid it on top of the heater pad against the RTV glue. After letting it sit for about 20 minutes I removed a corner of it and started to scrub with a microfiber towel and it came right up without issue.

8 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 5/2/2024 in #fix-my-printer

Best way to remove RTV glue from keenovo heater pad?

yea figured i was gonna have a tough time with it lol. I'll look into that. I had some luck with isopropol on a microfiber, but its taking forever. thanks!

8 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 3/27/2024 in #fix-my-mesh

beacon 1mm drop off after install

It was due to beacon going to far left over x and scanning the build plate. Adjusting the mesh_min setting solved it

7 replies

RRCRat Rig Community [Unofficial]

•Created by funtimeerror on 3/27/2024 in #fix-my-mesh

beacon 1mm drop off after install

sorry the range pics formating came out funny durring attaching images 😦 if you click on them you can see the data

7 replies

RRCRat Rig Community [Unofficial]