Dayum
RRCRat Rig Community [Unofficial]
•Created by Dayum on 12/11/2024 in #fix-my-printer
Z1 Drops after print
Hello I have the problem that my print bed sinks at the rear end (z1) after a print or after “save config”. It seems as if the weight of the bed itself is causing this.
Is there anything that can be done?
89 replies
RRCRat Rig Community [Unofficial]
•Created by Dayum on 11/26/2024 in #fix-my-printer
IDEX Commissioning - Endstop calibration problem?
8 replies
RRCRat Rig Community [Unofficial]
•Created by Dayum on 11/26/2024 in #fix-my-printer
"No Beacon model loaded" while Homing Z
After IDEX Upgrade, getting this error while homing. Tried BEACON_INITIAL_CALIBRATION and BEACON_RATOS_CALIBRATE BED_TEMP=85 without success, any ideas? Thx in advance!
4 replies
RRCRat Rig Community [Unofficial]
•Created by Dayum on 9/22/2024 in #fix-my-print
prints too large
hey i could use a tip 😉 i printed a 20mm^3 test cube which was .55mm too big on x and y. I then increased the rotation distance from 40 to 41.1 (calculated based on the deviation) and got exactly the same result (.55mm too big) when I printed the test again. What would be the next logical step to fix this problem?
113 replies
RRCRat Rig Community [Unofficial]
•Created by Dayum on 8/22/2024 in #fix-my-printer
Part cooling fat goes to 100% "randomly"
checked wiring, c hecked setup wizard, its on EBB43 digital pwm on 2pin port
55 replies