Clockwork Apocalypse
RRCRat Rig Community [Unofficial]
•Created by Clockwork Apocalypse on 3/7/2024 in #fix-my-printer
adxl345 crashing the MCU
I have been trying to follow the RATOS wiring for the octopus max ez to wire in a adxl345. The printer works fine without the adxl but the MCU will not boot with it attached. what do i need to do the wire the ADXL into the RPi ? I have run into issue with trying to get the SPI bus to work for other things so if i can avoid it that works better
10 replies
RRCRat Rig Community [Unofficial]
•Created by Clockwork Apocalypse on 2/4/2024 in #fix-my-print
heavy distortion between sliced file and print
4 replies
RRCRat Rig Community [Unofficial]
•Created by Clockwork Apocalypse on 2/1/2024 in #fix-my-printer
Looking for code lines for a BTT Octopus max EZ
I have done a lot with custom edits in marlin but am brand new to ratos/klipper and at a loss when trying to install a custom set of hardware options not listed in the ratrig default. I have a octopus max ez with the ez5160 stepper drivers in motor 1,2,3,5,6,7 and a two wire pt1000 running off an ez31865. What I am looking for is either the location of lines of code that needed to be edited or the framework to make additions in the users overrides section. I have looked at both the klipper documentation and the ratos guides and while they do give the outlines there are no libraries of code, that I could find, to assemble working commands from.
12 replies