TonyStyles
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 9/5/2024 in #ratos-support
RatOS-v2.1.0-RC2 How do I set configuration that is not included in the "Configurator"?
I just upgraded to the latest pre-release. I went through the Configurator. I have a handful of configurations I need to set. Things like neopixel, beacon y offset, adding additional temperature sensors, additional fan control, fan kick start time, etc.
I'm wondering, what is the prescribed method for these things?
I'd happily read the docs if they exist; it seems like the os.ratrig.com/docs is mainly 2.0? I realize this is a pre-release; I'm just trying to be self-sufficient and would gladly read the docs if they exist.
37 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 7/31/2023 in #fix-my-printer
Heater heater_bed not heating at expected rate See the 'verify_heater'
14 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 7/21/2023 in #fix-my-print
Default PrusaSlicer RatRig Settings - Voron Cube - Quality Issues
3 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 2/1/2023 in #fix-my-mesh
Needing help reducing range
6 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 2/1/2023 in #fix-my-print
First few layers are not consistent
5 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 1/27/2023 in #fix-my-print
Z dimension undersized
7 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 1/8/2023 in #fix-my-print
The start of print seems to miss the first few millimeters of extrusion
8 replies
RRCRat Rig Community [Unofficial]
•Created by TonyStyles on 1/3/2023 in #fix-my-print
Minor problems with ABS
16 replies