Buddienorway
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
So my printes sounds like shit when it prints small stuff kinda fast. Using ratos and prusaslicer.
Have yet to find something loose. So if anyone know where to look and what to rethightn please let me know.
Adding a video so you can hear it.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 6/16/2024 in #fix-my-printer
Beacon start up print Move out of range
6 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 2/7/2024 in #ratos-support
MCU issues
Did my flash and all. Did the update on the RatOS and then updated all the others after that. Then i got to the point to ionstall the V Core thee config. then when it restarts i get the MCU mcu unable to connect issue. Once the underlaying issue is corrected ese the firmware restart command to reset the firmware and reload the config
Anyone know what to do here? Second time i done this and got to the same point both times. I got the Manta M8P board and the CB1
111 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 7/23/2023 in #fix-my-printer
True Bed LvLing G32
So i have an issue now that makes my probe not read consistant anymore at front left point. This is something that started just now and i have no idea why.
My rig is a V Core Pro 1.3 with duet board on it.
My Config g is as follows
G31 offset X-56 : Y3
M557 Mesh Grid x 50:350 Y 50:350 S50
My Bed.g is as follows
M671 X-60:185:460 Y-20:480:-30 S 15
Any tips or tricks to make it even better? Or are these points good enough to do the bed well enough? I have the old anti backlash nut solution. Witch i dont like. Wondering about dooing the ball lead screw upgade to it. Bought the ball leadscrews already. https://www.printables.com/model/152335-ratrig-vcore3-ball-lead-screw-arms
Will this fit my V Core Pro 1.3 the arms look the same. Looks like i just need to move my MGN rails from the front to the inside. Also removing the old t joint on the V Core Pro.
1 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 7/20/2023 in #fix-my-print
retraction issues or
1 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 6/28/2023 in #fix-my-printer
Random layer shifts
3 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 12/1/2022 in #fix-my-printer
Ruby nozzle issues
7 replies