Buddienorway
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
Found the culprit. Was a corner bracket that wasn't connected correctly so the t nut dint lock into the frame. Locked in to the corner bracket making the Ali extrusion loose. Man this has been a mindboggle to figure out. But got it in the end.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
Thanks alot. dint think it would be found easily but to might get some tips on where to look. But ill keep on looking into stuff one by one part and hopefully ill find it before it breaks all the way.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
I can move the head around on the axis but its all thight and smooth yes. Its starting when acceleration is at 8000 and above. Should i set all that to 0 in prusaslicer and let the ratos take care of it? in the ratos settings?
11 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
I havent adjustet any of it. But only updated to the new prusaslicer and updated the ratos.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 8/13/2024 in #fix-my-printer
Rattling sound when printer does small moves.
No one got anywhere to even look to get this issue solved? I have now dismantled the one motor mount on the back right side. Too see if there is anything there worth looking at,
11 replies
RRCRat Rig Community [Unofficial]
•Created by 𝕾𝖎𝖎𝖓 on 6/16/2024 in #ratos-support
Manta m8p 2.0
Don't see any fan selection. I'll go and check that again then. Thanks.
17 replies
RRCRat Rig Community [Unofficial]
•Created by 𝕾𝖎𝖎𝖓 on 6/16/2024 in #ratos-support
Manta m8p 2.0
small question when you updated to RatOs 2.1 does your part fan still work? Mine wont spin anymore. Not sure if the pinouts changed in the setup or what happend. Will have to look into that.
17 replies
RRCRat Rig Community [Unofficial]
•Created by Buddienorway on 6/16/2024 in #fix-my-printer
Beacon start up print Move out of range
ok why wouldi get that message then
6 replies