N8boy
RRCRat Rig Community [Unofficial]
•Created by N8boy on 2/27/2025 in #fix-my-mesh
V-Core 4 - 300 - What is an acceptable range?
Thanks for your feedback, that's clear for me but how? I already slammed my hand against it and nothing really changed.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Jeb Bush on 2/3/2025 in #fix-my-resonance
First Time Doing Belt Tuning... Looking For Guidance
If you haven't figured out, I had something similar today: It was for me the filament sensor with made some noise.
The lower left screw is not really holding the sensor in place. Depending on how tight you screw the upper right screw and place the lower left corner of the sensor housing, the housing might hit the screw or the housing of the orbiter and make some rattling noise.
20 replies
RRCRat Rig Community [Unofficial]
•Created by TOYOTAprevia on 2/25/2025 in #ratos-support
[VC3.1-400][ratos 2.1.0-RC2] Do I have to restart from scratch?
Got the same as well, but followed the instruction, first RatOs, then configuration, then everything else.
The issue at my side was that Klipper was not updated completely so the sweeping vibration generate was not yet implemented.
After updating Klipper (again) everything worked
53 replies
RRCRat Rig Community [Unofficial]
•Created by DikkieKlijn on 4/17/2024 in #ratos-support
BTT kraken support.
Thanks for the details, I have decide to better use the octopus so I can be sure that I won't have the issues.
24 replies
RRCRat Rig Community [Unofficial]
•Created by DikkieKlijn on 4/17/2024 in #ratos-support
BTT kraken support.
Thanks for your response, but what does this mean for me exactly? Will the accuracy of my prints be worse, will steps be quit, will it be louder?
Is it possible to use it with the provided LDO Speedy Power Motors of the V-Core 4 or will I just have troubles with it?
Bought it a while ago for a different project which I have stopped in favor of the V-Core 4.
24 replies
RRCRat Rig Community [Unofficial]
•Created by DikkieKlijn on 4/17/2024 in #ratos-support
BTT kraken support.
Sorry for digging this thread out. But could you explain me this please a bit more in detail? According to the datasheet of the Kraken there is a max. current of 8A noted for M1-M4, but there is nothing stated that you need at least 7,5A steppers anywhere.
24 replies