Donald (⚔☯🧘 Instructor) Comments

The inside PTFE got mangled and was not open enough for filament. Pulled it out and replaced the tube. Now works and extrudes filament. Thanks for help.

13 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/24/2023 in #fix-my-printer

Unable to extrude (new printer)

Will check in few hours when I get home

13 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/24/2023 in #fix-my-printer

Unable to extrude (new printer)

Sounds like I need to take it apart to find the obstruction.

13 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/24/2023 in #fix-my-printer

Unable to extrude (new printer)

About 10-15 mm to load nozzle. Then nothing as it tries to extrude, just the gears clicking

13 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/10/2023 in #fix-my-mesh

move by 0.1mm for mesh alignment

Thanks for confirming mesh is good. Woodworking clamps worked great. The 3ft clamp was 1 inch too short so used 4ft clamp. In the other direction I used 2ft clamp. Opposing clamps with finger tight on handle. Then loosened one to get a slight movement.

9 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/10/2023 in #fix-my-mesh

move by 0.1mm for mesh alignment

9 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/10/2023 in #fix-my-mesh

move by 0.1mm for mesh alignment

Wood clamp works great. Use marker to make fine silver line on extrusion, tighten clamp to hold in place, loosen bolts and then lightly tighten one by one. Managed to move about 0.2mm and now have this mesh. Is this good enough?

9 replies

RRCRat Rig Community [Unofficial]

•Created by Donald (⚔☯🧘 Instructor) on 12/10/2023 in #fix-my-mesh

move by 0.1mm for mesh alignment

Thanks for correcting the axis labeling. Somehow I thought y=0 was at the back.
With the extra extrusion for the enclosure, I think they are going to move easier than in the video. Tapping with hammer seems like it is going to move a hanging extrusion way too much.

9 replies

RRCRat Rig Community [Unofficial]

•Created by absent-sapphire on 10/20/2023 in #fix-my-printer

Commissioning: can't do PID, no voltage to SSR/hotend heater. Octopus/Rapido HF/stock bed.

Did you confirm pin in printer.cfg matches the actual connection?

6 replies

RRCRat Rig Community [Unofficial]

•Created by adverse-sapphire on 10/20/2023 in #ratos-support

RatOS off the network, still printing

You could plug in keyboard, monitor, mouse ( or have a touchscreen connected) and log in locally.

6 replies

RRCRat Rig Community [Unofficial]