WarbossGork
RRCRat Rig Community [Unofficial]
•Created by WarbossGork on 11/29/2024 in #fix-my-printer
Vcore4 suddenly crashed and won't turn on anymore. -Printer is working again.
Was changing the filament when it suddenly the printer crashed and the fan went to 100%
Tried doing a firmware restart but didn't help, did a power off and power on. now 2 LED are blinking on the BTT board anyone seen this before?
It's seems to be stuck and never loads the firmware.
Error solving:
Tried to decouple the Raspberry.
Tried to disconnect 2 motors just to see.
Printer has been running for several months now.
Seems to be D49 blinking red and D29 blinking green
https://imgur.com/a/btt-octopus-led-list-description-N3TJGfG
2 replies
RRCRat Rig Community [Unofficial]
•Created by WarbossGork on 7/23/2024 in #fix-my-resonance
VC4 300 Enclosed - Belt tension gantry alignment
18 replies
RRCRat Rig Community [Unofficial]
•Created by WarbossGork on 6/18/2024 in #fix-my-print
Reverse elephant foot
6 replies
RRCRat Rig Community [Unofficial]
•Created by WarbossGork on 4/4/2024 in #ratos-support
variable_adaptive_mesh - Probe Count.
Anyone know how one would increase the probe count for the variable_adaptive_mesh macro?
20 replies
RRCRat Rig Community [Unofficial]
•Created by WarbossGork on 8/19/2023 in #fix-my-resonance
First belt test - vcore 3.1 300
6 replies