millenford - VC4 300h
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 10/7/2024 in #ratos-support
What causes "toolhead stopped below model range" and what can be done?
I'm rn
3 replies
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 10/7/2024 in #ratos-support
What causes "toolhead stopped below model range" and what can be done?
@Helge Keck I'm running RatOS 2.1 RC3, and have run the initial beacon cal, beacon_ratos_calibration, and beacon_create_scan_compensation_mesh bed_temp=85 profile=Contact. I've been getting the Toolhead stopped below model range and the Error during homing contact: Contact triggered while accelerating errors. The nozzle height looks normal when I get these messages.
11 replies
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 10/3/2024 in #ratos-support
Is there a range of numbers I can or should increase to avoid these messages?
3 replies
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 9/12/2024 in #fix-my-print
Are there standard test print STL's beyond the ratrig commissioning first layer test print?
I found some of course on thingiverse, but I'd like to use a standard set if they exist, vs just somebody's creation on thingverse.
17 replies
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 9/5/2024 in #ratos-support
Would an SSD (vs the SD card) speed up full updates on RPi 4B?
Would the full 8GB of optional RAM speed it up?
44 replies
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 8/13/2024 in #ratos-support
Getting occasional "mcu shutdown - timer too close" shutdowns.
162 replies
RRCRat Rig Community [Unofficial]
•Created by millenford - VC4 300h on 8/7/2024 in #ratos-support
This E-Stop code I pasted into the printer.cfg file is getting errors when I hit SAVE & RESTART.
I edited and trimmed the code down to this:
[gcode_button e-stop]
pin: rpi:gpio26
press_gcode:
{% do call_method("printer.emergency_stop") %}
release_gcode:
{% if event.elapsed_time > 1.0 %}
{% do call_method("machine.reboot") %}
{% endif %}
Resulting error:
Error loading template 'gcode_button e-stop:press_gcode':
jinja2.exceptions.TemplateSyntaxError: Encountered unknown tag 'do'.
26 replies