GRUB4D0S
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
Okay i fixed the problem. The thing was quite unfortunate. When I decided to reinstall ratos we somehow didn't have internet access that's why the c_helper function was missing. (I checked the
system status klipper.service and there was an error with the c_helper.os). So now I checked that I had internet access and reinstalled everything so now it works. Thanks for the help.15 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
15 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
15 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
I don't understand. When I try connect my pi with the motherboard and turn everything on, it says "moonraker can't connect to klipper". So I go under the configure steps and try to follow the steps again, but now I am stuck with the board flashing step. Could you please tell me the steps and what to look for under the /dev?
15 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
I don't have a camera connected. The weird thing is, OK I reintalled ratos but now I just cannot flash the motherboard. It says that the motherboard is unresponsive.
15 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
I have put an access point right next to the raspberry pi and it didn't want to connect, I also later just plugged and ethernet cable directly into the pi and nothing
15 replies
RRCRat Rig Community [Unofficial]
•Created by Digger738 on 1/27/2024 in #fix-my-mesh
V-Core 3.1 400 with bent X-Gantry?
if it prints good you're fine
3 replies
RRCRat Rig Community [Unofficial]
•Created by Arthur_C on 1/15/2024 in #fix-my-printer
XY-gantry (to) rigid
Great that you fixed the problem. I think that twisted 2020 extrusions are quite common. I had 4 3d printers until now and 2 of them had a twisted 2020 extrusion on the x axis.
10 replies
RRCRat Rig Community [Unofficial]
•Created by tcsjc on 1/24/2024 in #fix-my-mesh
V3.1 500 Mesh causing inconsistent print
Can you show a photo of your bed mesh
13 replies
RRCRat Rig Community [Unofficial]
•Created by Arthur_C on 1/15/2024 in #fix-my-printer
XY-gantry (to) rigid
I had the same problem, This is caused by a bend x axis extrusion i think. So i just inserted a shim or two in between the two parts and tightened the screws
10 replies