GRUB4D0S
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/29/2024 in #fix-my-print
not retracting
1 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/28/2024 in #fix-my-printer
Raspberry and mother board crashed
Today I was printing a calibration print, nothing special and I wanted to check how far along the print was and I couldn't connect to ratos through the web interface. When I checked the printer, the calibration print finished, raspberry pi and everything had power so there should be no reason for me not to be able to connect to it. So after a while I saw that ratos was hosting a wifi access point, just like at the beginning where you flash your motherboard and initialize your printer. So now I had to reinstall the ratos image to raspberry pi and now I am attempting to reflash the motherboard. Why would this happen? I grounded everything. The raspberry pi has it's own power source.
15 replies
RRCRat Rig Community [Unofficial]
•Created by GRUB4D0S on 1/26/2024 in #fix-my-mesh
Is this the best I can do ?
2 replies