Klonk
RRCRat Rig Community [Unofficial]
•Created by Klonk on 11/10/2024 in #fix-my-print
Vertical ripples/horizontal lines/Z-banding
10 replies
RRCRat Rig Community [Unofficial]
•Created by Klonk on 10/9/2024 in #ratos-support
Problems with Orbiter Smart Sensor
I installed an orbiter smart sensor on the toolhead. Seems to work fine. I configured printer.cfg according to: https://github.com/HelgeKeck/RatOS/blob/documentation_v2.1/site/docs/configuration/filament_sensors.md#orbiter-smart-filament-sensor-example-configuration
but shouldn't pressing the button unload the filament? On my machine nothing happens. No heating and unloading of hotend.
For testing I changed in my printer.cfg:
[filament_switch_sensor toolhead_filament_sensor_t0]
pause_on_runout: False
event_delay: 0.1
switch_pin: ^toolboard_t0:PB3
runout_gcode:
RATOS_ECHO MSG="runout"
insert_gcode:
RATOS_ECHO MSG="insert"
[gcode_button toolhead_filament_sensor_button_t0]
pin: ^toolboard_t0:PB4
release_gcode:
RATOS_ECHO MSG="pressed"
press_gcode:
Only inserting the filament gives the message "insert". Removing it should normally give "runout" as I simulate a runout, but nothing happens. When pressing the button nothing happens.
The sensor status "empty" and "detected" is correctly shown under Tab "Miscellaneous"
Any ideas?
Im running RatOS2.1RC3-0
I got this version: https://de.aliexpress.com/item/1005007527028984.html17 replies
RRCRat Rig Community [Unofficial]
•Created by Klonk on 9/29/2024 in #fix-my-print
VCore4 printing Overture Nylon Z-Offset too high.
As I understand the Z-Offset is measured every time I print (by beacon). I had problem that print using Overture Nylon always got off the bed. I then found the Z-Offset was set to 0.069 instead of 0.059. After changing the Z-Offset to 0.059 everything is fine and the print does not lift from the bed.
I'm just guessing here, but maybe the temperature is not high enough to do a proper wipe of the nozzle on the bed.
Nevertheless, does anyone have an idea what to do to fix this on each print without manually changing the z-Offset after the print has started??
Is there a way to increase the wipe temperature for a specific filament (maybe additional gcode)?
Or is there a way to prevent automatic Z-Offset measurement when using a specific filament?
Any ideas or suggestions?
2 replies
RRCRat Rig Community [Unofficial]
•Created by Klonk on 9/25/2024 in #fix-my-resonance
Please comment VC4-300 CoreXY and Hybrid
7 replies