Grimstod
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 3/11/2024 in #fix-my-printer
Odd Z error
I have had this odd error. Can anyone tell me what i need to do to fix it?
14 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 7/15/2023 in #fix-my-printer
RSS faulty?
1 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 6/4/2023 in #fix-my-print
printing round tubes
12 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 3/15/2023 in #fix-my-resonance
Before and after impute shaper shows no change
12 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 3/7/2023 in #fix-my-printer
Octopus 1.1 firworks
I will say the new RatOS is much easier to fallow on settup. But i clearly still have an electrical problem somewhere.
23 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 1/22/2023 in #fix-my-printer
octopus 1.1 is it fried?
Last week i noticed my finda probe light was out. When i felt the wire it was hot. Even burned me. So I unplugged it and immediately my pi started putting out smoke. Today i hooked up a new pi and when i turned the power on my BTT filament sensor started putting out huge amounts of smoke! Filled the basement even.
Is my octo board fried? Or should i look at the power supply. Octo board lights up as it should.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 1/7/2023 in #fix-my-printer
Changing hottend cfg help
I just moved over from the dragon to a Paetos rapido UHF. Not by default the hottemd temp is always 160c
41 replies
RRCRat Rig Community [Unofficial]
•Created by Grimstod on 12/31/2022 in #fix-my-print
Some PETG prints to work on improving
25 replies